Fitting Instructions

Here is our Fitting kit: Number Plate Fixing Kit / Fitting Set for Cars / Motorbikes - Screws Sticky pads

 

Follow these steps to fit your plate...

 

For fitting with our sticky pads:

1. Remove the old plate, clean the area where the new plate is to be fitted.

2. Apply adhesive pads to the plate, and remove the film from them.

3. Position the plate over desired location, ensuring it is straight and level.

4. Once in correct position press the plate down firmly, and the adhesive pads will stick.

5. Peel away the protective film from the plate.. And your all done!

(Caution: Some sticky pads will damage the plate, we will not warranty this. So make sure our sticky pads are used)

 

For fitting with screws/bolts see below..

1. Remove the old plate, clean the area where the new plate is to be fitted.

2. Place the old number plate on top of your new one and use it as a guide to measure where the holes need to be drilled into the new plate.

3. Carefully drill through the holes and into your new plate with an appropriately sized drill bit.

4. We recommend putting sticky pads on the back of the plate, this prevents damage to the backing during vehicle use.

5. Fix the plate to your vehicle using the screws/bolts – (Caution: Do not over tighten as this will damage your plate)

6. Peel away the protective film from the plate.. And your all done!

 

If fitting to a permanently curved surface like a curved hanger bracket or curved mudguard..

We recommend a stick on type plate, please give us a call.